PTA - PARTITION TOP ANCHORS
PTA SERIES PARTITION TOP ANCHORS are engineered products that are project-specific, and have been developed to provide lateral shear resistance at the upper limit of masonry walls. They permit vertical deflection of the slab above while resisting positive and negative lateral shear loads, without transferring compressive loads to the masonry wall below. PTA Series Anchors are suitable for construction using steel or concrete. PTA Tube with expansion filler is placed over rod anchor, which has been attached to concrete or steel by any of the methods illustrated. The vertical joint is then filled with mortar, fully surrounding tube. Other sizes available for heavy-duty applications.
PTA-310 & PTA-310-HS
PTA-310 - #3 rebar rod with 3/16” thick Dovetail Head. PTA-310-HS - Standard - 5/8” rod with 1/4” thick Dovetail Head. - For use on concrete construction. - Must be used in conjunction with H&B #305 Dovetail Slot and PTA Tubes.
U.S. Patent 8,978,326. Other Patents Pending. Finishes: Hot-Dip Galvanized or Stainless Steel.
PTA Tubes Grey plastic Tubes filled with compressible polyethylene filler. For use with PTA-310, 310-HS and 420-HS anchors.
Standard - #3 rebar with 3/16” thick plate containing 5/16” diameter holes - For use on concrete or steel beam construction. - Use with PTA Tubes. Finishes: Hot-Dip Galvanized or 304 Stainless Steel (316 Special Order).
HB-LSA-1 & HB-LSA-2
Standard - 12 gauge thick with 2-1/2” standard bends. Widths to fit 4”-12” block. Use as a Lateral Support Anchor for concrete or steel beam where the slab and wall are offset. LSA Anchors comply with CSA A370-14. Finishes: Hot-Dip Galvanized or 304 Stainless Steel (316 Special Order).
Standard - 12 gauge thick with 2” standard bends. Widths to fit 4”-12” block. Use on concrete or steel construction. Provided with two 7/16” holes for mounting hardware. Finishes: Mil Galvanized, Hot-Dip Galvanized or 304 Stainless Steel (316 Special Order).
www.h-b.com | 800-645-0616
Powered by FlippingBook