HOHMANN & BARNARD, INC.
FLASHING SYSTEMS
TeXtroflash ™
This 40-mil thick composite membrane is made with a synthetic-rubber adhesive that offers superior adhesion for optimal performance. This adhesive is factory- laminated to a woven-reinforced polyethylene sheeting, yielding a flexible membrane that is suitable for application to masonry, concrete, steel, gypsum and wood. - Provides dual-layered waterproofing protection. - Resists tearing and slicing. - UV-resistant for up to 90 days. - Adhesive backing will not leach out when exposed to UV or heat. Note: H&B recommends using stainless steel corners and end dams for optimal waterproofing protection. Use Primer-SA™ and HB Sealant for proper installation. Available Widths: 12”, 16”, 18”, 20”, 24”, 36”, 48”, 54”, 60” & 72” wide x 75’ long rolls. Other sizes available upon request. U.S. Patents: 7,823,355 and 7,882,673. Other Patents Pending.
2
1
3
1. TeXtroflash ™ Flashing 2. T1 OR T2 TERMINATION BAR required for surface-mount application 3. DRIP PLATE/EDGE strongly
recommended for surface-mount or thru-wall application
Flex-Flash ® Flashing
Moisture infiltration can occur at sills, projections, recesses, intersections and mortar joints. The solution begins with proper flashing. H&B’s Flex-Flash® is a 40-mil thick product formulated with Elvaloy® Kee*. It does not seep and combines the best features of other types of flashing, making it a truly superior product. - Extremely tough, with excellent impact and tear resistance. - Flexibility is maintained in all weather environments, even in extreme heat or cold. - Highly resistant to oils and repels most chemicals. - Not susceptible to UV degradation. component that can leach out of the building in warm temperatures if not precisely installed, leaving unsightly marks that are difficult to remove. Flex-Flash ™ has a pressure-sensitive, clear adhesive that will not seep when exposed to UV or heat. Flex-Flash® may be used in thru-wall or surface-mount applications. For surface-mount applications, apply to clean, dry surface. For surfaces where additional adhesion may be required, use H&B Foam-Tak™ Hi-Performance Spray Adhesive. Termination Bars must also be used. Flex-Flash® should be extended beyond the wall face and cut flush with the brick. Optional Drip Plates may be used to effectively guide moisture to the exterior. For maximum protection against moisture infiltration, specify the complete Flex-Flash® Flashing System, comprised of Flex-Flash®, Mortar Trap™, Foam-Tite Seal™ Drip Plates and Termination Bar. U.S. Patents: 6,584,746. Other Patents Pending. - Compatible with most silicone and urethane sealants. - Suitable for thru-wall or surface-mount applications. Typical “peel-and-stick” flashings have a black, rubberized-asphalt
Surface Mount
Thru-Wall
*Elvaloy is a registered trademark of the DuPont Company.
51
For material conformances, submittal sheets, CAD drawings and SDS sheets visit: www.h-b.com
Powered by FlippingBook