MASONRY SYSTEMS
REINFORCED VENEER SYSTEMS FOR SEISMIC AND CRACK CONTROL
Channel-Tee Seismic-Notch Anchor System
Ideal for use where maximum vertical adjustability is preferred. The Continuous Channel is surface mounted to the back up. The Seismic-Notch Anchor is then easily inserted into the channel anywhere along the vertical length to conveniently fit wherever the mortar joint lies. Continuous joint reinforcing wire is easily inserted into the seismic notches of each anchor. - Thin 5/8” profile of channel is ideal for tight cavity conditions. - Channel provided in 10’ lengths. - Holes drilled 12” on center in channel. - Also suitable for use on concrete or CMU. Seismic-Notch Anchor available 14 ga. thick by 3”, 3-1/2”, 4”, 4-1/2” or 5” long. (Other sizes available upon request). Available Hot-Dip Galvanized or 304 Stainless Steel.
HB-213S Veneer Anchor
#345 SV Seismic-Notch Veneer Anchor
Formerly known as T-LOK TIE™. The configuration of the HB-213S Seismic Plate Pintle allows easy insertion into slot, while preventing future disengagement. This also prevents the tie from being installed beyond allowable eccentricity. Standard Sizes: Pintle portion: 3½” or 4½” long, 12 ga. or 11 ga. thick. Backplate portion is fabricated to accommodate various wallboard/insulation combinations. Specify thickness when ordering.
Same availability as above with bent end and 9/32” diameter hole to accommodate hardware. Includes bent end and 9/32” diameter hole to accommodate hardware. Made to order in any length.
#303 SV Seismic-Notch Dovetail Anchor
#364 SV Seismic-Notch Gripstay ™ Anchor
1 ¼” wide x 14 ga. or 12 ga. thick with a standard dovetail head. Includes a standard Gripstay notch. Use with any style H&B Gripstay Channel. Made to order in any length.
1¼” wide x 14 ga. or 12 ga. thick with a standard dovetail head. Use with the #305 dovetail slot. Made to order in any length.
20
www.h-b.com | 800-645-0616
Powered by FlippingBook