VENEER ANCHORS & TIES
2X-HOOK TM
Tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (TMS 402/602) of 1¼” (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard “round wire” hooks/pintles by over 100%, while maintaining the ASTM A1064/1064M wire specification. - The embedded portion of the 2X-Hook is 3/16” DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8”) must be twice the diameter of the wire. Available Lengths: 3”, 4”, 5”, 6” or 7” long. U.S. Patent: 8,613,175.
3/16ӯ WIRE
COMPRESSED VERTICAL LEGS
HB-213 for Stud Backup
Adjustable veneer anchor accommodates various wallboard and insulation combinations up to 6” thick. L-shaped plate with ribs for added strength and two 9/32” diameter holes to accept various screws. Fabricated to accommodate various wallboard/insulation combinations. Specify thickness when ordering. - Slot allows for 2X-HOOK™ insertion and are sized to prevent in-and-out movement beyond allowable tolerances. - Available with Seismic Hook and Continuous Wire. Back Plate: 14 ga. or 12. ga thick. Finishes: Hot-Dip Galvanized or 304 Stainless Steel (316 Special Order).
VBT- VEE BYNA-TIE ®
For use with H&B’s DW-10 Series Anchors, X-Seal ® Anchors (tying brick veneer to steel studs), or #359 Series Weld-On Ties (tying masonry walls to steel columns). Standard Sizes: 3/16” or 1/4” diameter X 3”, 4”, 5”. Other sizes available upon request. Finishes: Hot-Dip Galvanized or 304 Stainless Steel (316 Special Order).
9
For material conformances, submittal sheets, CAD drawings and SDS sheets visit: www.h-b.com
Powered by FlippingBook